
Regency
®
Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98
33
5.14 Timers (Menu 13)
SHUTDOWN:90s
Decide the number of seconds that you want the audible alarms to be active. Then divide this
number by 10 and enter the result (1-255).
EXIT:30s
Enter (in seconds) the length of the exit delay (1-255).
ENTRY1:30s
Enter (in seconds) the length of the entry delay for zones controlled by Entry Delay #1 (1-255).
ENTRY2:60s
Enter (in seconds) the length of the entry delay for zones controlled by Entry Delay #2 (1-255).
SWINGER BYP:4h
Enter (in hours) the length of the swinger window (1-24 hours). If the SWINGER BYPS
option has been selected (SYSTEM, Menu 5), a swinger bypass (shunt) will occur on the fifth
trip when a zone has caused four alarms within this time period.
RF SUPRV:24h
Enter the supervision interval in hours (2-24 hours).
EXAMPLE: If you enter 3, the system will check for supervisory transmissions from the
RF transmitters every three hours.
DOOR STRK:6s
In this step, you’ll program the length of time that the doorstrike stays activated (1-15 sec-
onds). Some older touchpads (4433, 4420) use .8 second units, so the duration of the door
strike will be .8* the time programmed.
NOTE This time period is the maximum length of time the doorstrike will remain activated, allowing
someone to open the door. If a door contact is connected to the touchpad, the doorstrike will
turn off one second after someone opens the door. If no door contact is connected to the touch-
pad, the doorstrike will remain activated for the programmed length of time, regardless of
whether the door has been opened during that time.
DOOR OPEN:60s
Enter (in seconds) the maximum time that the door can remain open before the system will
send a Door Left Open Report (1-255 seconds).
REP DELAY:15s
Enter (in seconds) the amount of delay that you wish to have between the time that an alarm
condition is sensed and when the system will actually report the alarm (1-255 seconds).
Delayed reporting is selectable by zone in Zone Options (Menu 8).
SMOKE RST:2s
Enter the number of seconds the smoke detector power is turned off after the smoke detector
has been reset (1-15 seconds).
MENU TIME:10s
For this option, you enter the area arm menu time (0-255 seconds).
Kommentare zu diesen Handbüchern