Regency 4734 Installationshandbuch PDF herunterladen (Seite 55)

Regency

Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98

4. As computer keys are pressed, they are buffered and shown after the “Keys:” heading at

the top of the status window. The keystrokes are not actually sent to the panel, until

ENTER is pressed on the keyboard. After the keystrokes have been sent, the “Keys:” area

is blank. The display will take up to four seconds to respond to the keys sent to the panel

because of the relatively slow transmission rate.

EXAMPLES:

Zone status: Press N and ENTER to display Not Ready Zones. The zones are displayed

along with their location text and area one at a time.

Set time: Press 9 T then enter a valid programming code (such as Code 0). Press ENTER.

The display will show the set time display. Enter the digits for the time, then press T to

enter the data.

Built-in programmer: Press1 1 T then enter Code 0. Press the ENTER key. The display

will show the main menu for the built-in programmer. The programmer is operated just

like it is from a touchpad. A special feature of the downloading software allows you to

program zone locations and system messages directly.

When the display is in the program menu for a text option (the bottom line scrolls groups

of symbols

—as described in Section 4.5 of this manual), press the F1 function key on the

computer. The display F1:ASCII will change from black to red. Now type in the letters

you want to program and press the ENTER key. The letters will be entered directly into

the display. Press F1 again to return to the Normal Key Mode. (F1:ASCII must be off to

emulate the TEST key and other functions).

When the ESC key is pressed to terminate Status Mode, the system will return to normal

operation.

6.3 Uploading Event Memory

When the Panel Interface Menu appears, select M to upload event memory from a particular

account and save it on a disk at the central station.

Enter the account number when prompted to do so. The letter “E” will appear, followed by the

account number, on four different lines of the Up/Downloads column.

Initiate an upload, either by dialing the panel from the computer or by having someone press 4

TEST on a touchpad at the account location.

Select C to save the upload, then enter the account number to be saved. Event information will

be saved in an ASCII file. The name assigned to the file will be the account number with the

extension .EVT on the end.

NOTE The 4734’s event memory is NOT cleared when the information is uploaded.

6.4 Programming Procedure

See Section 6.5 of this manual for instructions on programming auxiliary device outputs using

the 5540 software.

6.4.1 Reprogramming the Options

1. When the Panel Interface Menu appears, press A to reprogram any of the options. You

will be prompted for an account number to edit.

2. On the Edit Account Menu, select the type of options you wish to program.

3. When you finish programming the options on one of these menus, press ESC to get back

to the Edit Account Menu, then choose another set of options to program. After you have

reprogrammed all the options you wish, press ESC again. Then follow the screen prompts

to save and download the new data.

4. After you have entered the subscriber’s phone number, the number will appear on the

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

Regency 4734 Installationshandbuch Seite 55

Kommentare zu diesen Handbüchern