Regency Excalibur EX-E33 Large Gas Insert Bedienungsanleitung

FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC, Canada V4G 1H4918-513cWARNING: Improper installation, adjustment, alteratio

10E33 FPI Direct Vent Gas InsertINSTALLATIONMINIMUM CLEARANCES TO COMBUSTIBLES From Unit Side Walls * A 8" (203

E33 FPI Direct Vent Gas Insert11INSTALLATIONGAS CONNECTION 1) If the appliance is to be installed into an existing chimney system, thoroughly clean t

12E33 FPI Direct Vent Gas InsertINSTALLATIONOPTIONAL BRICK PANELOptional Brick Panel Set:Part # Description Qty Top (brick) panel 1 Ba

E33 FPI Direct Vent Gas Insert13INSTALLATIONDiagram 1Installation of Brick Panels:1) Remove top louver and glass door if installed.2) Remove the log

14E33 FPI Direct Vent Gas InsertINSTALLATIONGas Log Kit #340-930 contains the following:03-17 Bottom Log 03-18 Center Top Log03-19 Front Log03-20 Left

E33 FPI Direct Vent Gas Insert15INSTALLATION7) Align the bottom grooves of log 03-21 onto the right side of the grate and gently slide the log back u

16E33 FPI Direct Vent Gas InsertINSTALLATION03-1703-2003-2303-2203-18Diagram 1011) Place log 03-24 over log 03-23 and log 03-21 ensuring the pin hole

E33 FPI Direct Vent Gas Insert17INSTALLATIONEach Kit contains one LPG Conversion Kit and one DC Sparker Kit.LPG Conversion Kit Contains:Qty. Part # D

18E33 FPI Direct Vent Gas InsertINSTALLATIONWARNING!Do not over tighten the screw. Recommended togrip the wrench by the short side.15) Using the Allen

E33 FPI Direct Vent Gas Insert19INSTALLATION31) Locate the ground lug at the receptical box, left of the unit.32) Connect one end of the supplied gree

2E33 FPI Direct Vent Gas InsertFPI GAS FIREPLACE INSERTTO THE NEW OWNERCongratulations! You are the owner of a state-of-the-art Gas Insert by FPI.The

20E33 FPI Direct Vent Gas InsertINSTALLATIONDiagram 511) Push the FPI logo plate into the two holes in the bottom left corner of the faceplate.10) Att

E33 FPI Direct Vent Gas Insert21INSTALLATIONCONTEMPORARY FACEPLATE &DOOR FRAME1) Bring the faceplate up in front of the unit and connect the red

22E33 FPI Direct Vent Gas InsertINSTALLATION6) Place 2 screws through the screw holes on the hinge and place a spacer over each screw.7) Secure the

E33 FPI Direct Vent Gas Insert23INSTALLATION1) Attach the inner faceplate panel to the insert body using 4 screws in the locations shown below.Diagra

24E33 FPI Direct Vent Gas Insert46-15/32” (1180)42-7/16” (1078mm)26-3/4” (678mm)28.11/16” (729mm)33-5/16” (846mm)18-7/16” (467mm)INSTALLATIONDiagram 9

E33 FPI Direct Vent Gas Insert25INSTALLATIONThe standard fl ush door comes with a black frame. To install the frame, simply hook the top door fl ange on

26E33 FPI Direct Vent Gas InsertINSTALLATION1) Align the left side Faceplate Trim Bracket with the Firebox Flange and secure using 2 screws as shown

E33 FPI Direct Vent Gas Insert27INSTALLATION1) Remove the rivets from the surround by pulling off the hoseclamp (located at the backside of surround)

28E33 FPI Direct Vent Gas InsertINSTALLATIONWIRING DIAGRAMSThis heater does not require a 120V A.C. supply for operation. However, a 120V A.C. power

E33 FPI Direct Vent Gas Insert29INSTALLATIONUse the FPI Remote Control Kit approved for this unit. Use of other systems may void your warranty.The rem

E33 FPI Direct Vent Gas Insert346-15/32” (1180)42-7/16” (1078mm)26-3/4” (678mm)28.11/16” (729mm)33-5/16” (846mm)18-7/16” (467mm)10-11/16”(271mm)DIMENS

30E33 FPI Direct Vent Gas Insert30OPERATING INSTRUCTIONSIMPORTANT: Gas on/off knob cannot be turned from "PILOT" to "OFF" unless i

Regency Gas Fireplace31OPERATING INSTRUCTIONSCOPY OF LIGHTING INSTRUCTION PLATEAUTOMATIC CONVECTION FAN OPERATIONThe fan operates automatically. Turn

32E33 FPI Direct Vent Gas InsertMAINTENANCEGENERAL VENT MAINTENANCEConduct an inspection of the venting system semi-annually. Recommended areas to ins

E33 FPI Direct Vent Gas Insert33MAINTENANCEFAN MAINTENANCEIf your fan requires maintenance or replacement, access to the fan is through the plate on t

34E33 FPI Direct Vent Gas InsertMAINTENANCE11) Disconnect the inlet gas line.12) Unplug the black and red wires at the valve. Undo the 2 TP wires at t

E33 FPI Direct Vent Gas Insert35PARTS LISTMAIN ASSEMBLY Part # Description 1) 340-038 Fan Access Plate2) 340-

36E33 FPI Direct Vent Gas InsertPARTS LISTBURNER & LOG ASSEMBLY Part # Description

E33 FPI Direct Vent Gas Insert37PARTS LIST838485868788888888899090FULL SCREEN FRONT Part # Description

38E33 FPI Direct Vent Gas InsertPARTS LISTFACEPLATES, TRIMS AND HEARTHS Part # Description

E33 FPI Direct Vent Gas Insert39PARTS LISTCONTEMPORARY FACEPLATE & DOOR FRAME Part # Description

4E33 FPI Direct Vent Gas Insert4TABLE OF CONTENTSExcalibur Screen Doors ...27Excalibur Accent Kit ...

40E33 FPI Direct Vent Gas InsertPARTS LISTLOW PROFILE FACEPLATE Part # Description1) * Backplate Assembly2) * Bo

E33 FPI Direct Vent Gas Insert41NOTES

42E33 FPI Direct Vent Gas InsertNOTES

E33 FPI Direct Vent Gas Insert43WARRANTYRegency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Qua

Printed in CanadaRegency and Excalibur are trademarks of FPI Fireplace Products International Ltd. © Copyright 2010, FPI Fireplace Products Internatio

E33 FPI Direct Vent Gas Insert5SAFETY LABELThis is a copy of the labels that accompany each E33 Gas Insert. We have printed a copy of the contents her

6E33 FPI Direct Vent Gas InsertREQUIREMENTS5.08: Modifications to NFPA-54, Chapter 10(2) Revise 10.8.3 by adding the following additional requirements

E33 FPI Direct Vent Gas Insert7INSTALLATION4) See general construction and assembly instructions. This appliance may only be installed in a vented, n

8E33 FPI Direct Vent Gas InsertINSTALLATIONGAS PRESSURE TESTINGThe appliance must be isolated from the gas supply piping system by closing its individ

E33 FPI Direct Vent Gas Insert9INSTALLATIONMATERIALS REQUIREDNo electrical power supply is required for the gas control to operate. A 120 Volt AC pow