Regency LAFAYETTE (LF) Bedienungshandbuch

• CEILING FAN OWNER'S MANUAL • WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.Style that r

ELECTRICAL CONNECTIONS* Be sure electricity is turned off at the main power box before wiring.1. Four wires are connected to the fan. Black - this

BLADE ATTACHMENT1. Place fiber washer on screw. Insert this assembly through the blade and start the screw into the blade arm. Repeat this procedure w

INSTALLATION OF REMOVABLE SWITCH HOUSING3. If installing light kit, carefully remove light kit plug in bottom of switch housing. Attach light kit to s

OPERATIONTurn on the power and check operation of the fan. The fan is controlled by the use of the pull chain as follows: one pull = high speed

CARE AND CLEANINGPeriodically it may be necessary to re-tighten blade to blade arm screws or blade arm to motor screws to prevent clicking or humming

GENERAL INSTALLATION & OPERATION INSTRUCTIONSIMPORTANT SAFEGUARDS:1. To ensure the success of the installation, be sure to read the instruction

IMPORTANT SAFETY PRECAUTIONS• Disconnect power by removing fuse or turning off circuit breaker before installing the fan and/or optional lighting.Disc

UNPACKING YOUR FAN1. Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary, the fan s

PREPARATIONPREPARATION:Verify you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motor from pac

INSTALLING THE FANThe HUGGER method is preferred if maximum headroom is required. The ceiling must be horizontal, not sloped. Blades will be approxima

INSTALLING THE FAN - HUGGER STYLENOTE: The S hook is to be used for hugger style mounting.1. Remove the plastic trim ring from the canopy to expose th

INSTALLING THE FAN - DOWNROD STYLE1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come out) f

INSTALLING THE FAN - DOWNROD STYLE1. Lift ball/downrod/fan into hanger bracket opening. NOTE:NOTE: The tab opposite hanger bracket opening should fit